LEDVANCE SMART PLUS PLUG CH

LEDVANCE SMART PLUS PLUG CH based on BK7231T chip (WB2S). Can be flashed with esphome kickstart via tuya-cloudcutter. voltage_divider, current_resistor and multiply are estimated and can be adjusted according this instructions.

Product Image

GPIO Pinout

Pin	Function
GPIO6	Relay
GPIO7	Button
GPIO10	LED
GPIO11	BBL0937SEL
GPIO24	BL0937CF1
GPIO26	BL0937CF

Basic Configuration

# LEDVANCE SMART+ PLUG CH
substitutions:
  device_name: ledvance-pm-ch
  device_name_letters: ledvancepmch
  device_description: LEDVANCE SmartPlus Plug CH
  friendly_name: LEDVANCE SmartPlus Plug CH
  update_interval_seconds: "10s"

esphome:
  name: ${device_name}
  friendly_name: ${friendly_name}

# LibreTiny Platform
bk72xx:
  board: wb2s

# Enable logging
logger:

# Enable Web server
web_server:
  port: 80

# Enable Home Assistant API
api:
  encryption:
    key: <set here>

# Enable upload binaries over-the-air
ota:
  - platform: esphome
    password: <set here>

# Wifi Settings
wifi:
  ssid: <set here>
  password: <set here>

  # Enable fallback hotspot (captive portal) in case wifi connection fails
  ap:
    ssid: ${device_name}_fallback
    password: <set here>
captive_portal:

button:
  - platform: restart
    name: Restart ${device_name}

debug:
  update_interval: ${update_interval_seconds}

text_sensor:
  - platform: debug
    reset_reason:
      name: Reset Reason
  - platform: libretiny
    version:
      name: LibreTiny Version
  - platform: wifi_info
    ip_address:
      name: ESP IP Address
    ssid:
      name: ESP Connected SSID
    bssid:
      name: ESP Connected BSSID
    mac_address:
      name: ESP Mac Wifi Address

sensor:
  - platform: uptime
    name: Uptime
    unit_of_measurement: minutes
    filters:
      - lambda: return x / 60.0;

  - platform: wifi_signal
    name: Wifi Signal
    update_interval: 60s

  - platform: hlw8012
    model: BL0937
    cf_pin:
      number: P26
      inverted: true
    cf1_pin:
      number: P24
      inverted: true
    sel_pin:
      number: P11
      inverted: true
    current:
      name: BL0937 Current
      filters:
        - multiply: 1.0 # adjust this
    voltage:
      name: BL0937 Voltage
    power:
      name: BL0937 Power
    energy:
      name: BL0937 Energy
    update_interval: ${update_interval_seconds}
    voltage_divider: 800 # adjust this
    current_resistor: 0.001 # adjust this

binary_sensor:
  - platform: gpio
    id: binary_switch_1
    pin:
      number: P7
      inverted: true
      mode: INPUT_PULLUP
    on_press:
      then:
        - switch.toggle: switch_1

switch:
  - platform: gpio
    id: switch_1
    name: Relay 1
    pin: P6
    on_turn_on:
      - light.turn_on: light_status
    on_turn_off:
      - light.turn_off: light_status

light:
  - platform: status_led
    id: light_status
    pin: P10